Eventide h910 harmonizer vst manual#
Eventide h910 harmonizer vst software#
Eventide h910 harmonizer vst professional#

This control sets the overall balance of wet (effected) signal to When the Power button is IN the unit is powered up and operational, and when it is OUT the unit is powered off and the plug-in bypasses. Clockwise rotation increases decay time until feedback reaches unity, at which point the system will begin to oscillate. Used to determine the decay time of the output delay.

This second delay tap is fed from the same input as the first, and it also allows you to mix another delay into the wet output using the mixer section in the second panel. The OUTPUT 2 delay buttons control the amount of delay time for the second output. When in pitch mode only the right two buttons are active for 30 ms each, allowing for up to 60 ms of additional delay (30+30). When in DELAY ONLY mode, select delay times in 7.5 ms increments to a maximum of 112.5 ms. This is visual jitter only, and does not affect the audio.Īllow you to insert additional delays before the output. (See also ‘Pitch Ratio Readouts for Various Musical Relationships’.) Note that, just as in the original unit, when the knob is set between two values, the display will “jitter” between the two. The display shows the numerical pitch ratio.

Eventide h910 harmonizer vst manual#

The pitch ratio is nominally 1.0, but when input signal is applied it will modulate toward the setting of the MANUAL knob as determined by the ATTACK, RELEASE, and SENSITIVITY knobs.

ENV When selected, pitch ratio is determined by the ENVELOPE FOLLOWER.

KYBD When selected, pitch ratio is determined by the HK941 keyboard below, or by receipt of MIDI Note On and Pitch Bend messages (see “Working with the Harmonizer®” for more detail).

Note that higher settings will make the effect more audible, so care should be taken to find a setting which provides adequate feedback reduction with minimal audience/performer disturbance. This serves to decrease the effect of room resonance peaks on the signal which ultimately return to the microphone.

A-F This switch activates the ANTI-FEEDBACK knob, allowing you to add small amounts of an up-and-down frequency shift to the output signal.

Intermediate settings produce fractional octave ratios with the changes “bandspread” around unity. When fully clockwise, the output pitch is increased by 1 octave (ratio=2). When fully counterclockwise, the output pitch is decreased by 1 octave (ratio=.5).

MAN This switch activates the MANUAL control knob.

The four switches in this group allow you to select whether the pitch change is set by the manual knob (MAN), the anti-feedback oscillator (A-F), the HK941 keyboard and MIDI (KYBD), or the Envelope Follower (ENV). (Note that the Limit Indicator is “after” the Input Level and Feedback controls, so it will illuminate when internal clipping is about to occur due to excessive input level or feedback.) Adjust the Input Level so that the Limit Indicator flashes only on input peaks. When the Line control is IN the LED is on and the unit is actively processing audio when it is OUT the LED is off and the unit is bypassed and passes audio directly from input to output. The H910 plug-in also includes additional Mixer and Envelope Follower sections which allow you to utilize the second delay output and control voltage input options that were available in the original hardware H910. Simply assign the connected controller to the H910’s MIDI channel (see: “Working with the Harmonizer®” for more detail.). The original HK940 keyboard option is included and augmented with modern MIDI control that allows you to “play” the desired pitch using MIDI notes or bend it via pitch wheel. The plug-in captures all the realism of the original, including its “glitching” as it modifies the pitch. It offered built-in delay, manual adjustment of +/- 1 octave and even had an “Anti-Feedback” mode which helped to eliminate feedback between a mic and speaker by constantly “riding” room modes. The Eventide Clockworks H910 Harmonizer® was the world’s first harmonizer and one of the first commercially-available digital audio products.

Eventide h910 harmonizer vst software#

This helps us keep you informed of any important software updates, and any special offers that may only be available to registered users. We’ll get into more depth on the product soon but, before you forget, please take a few minutes to register online. This package includes a stunning recreation of the H910 Harmonizer®, as well as a Dual H910 version, which recreates the popular technique of running two H910 units in parallel to create lush doubling and other interesting effects. For over 40 years, innovative products like these have made Eventide an industry leader, and we are extremely proud that they continue to be in demand today.

Eventide h910 harmonizer vst professional#

The product recreated in this plug-in was among the first introduced by Eventide – and among the world’s first commercially available professional recording products.

Thank you for your purchase of the Eventide H910 Harmonizer® plug-in. 11ģ.2 Playing the Harmonizers with a MIDI Keyboard.